Multi pattern flasher

A six channel headlamp flasher with a choice of user selectable patterns. Headlamps and front fog lamps are controlled by the 4 main channels while channels 5 and 6 are dedicated to rear red operation. Internal DIL switches enable the user to select flash patterns of alternating, simultaneous, quad and multi-flash for head and fog lamps. In addition, rear patterns of simultaneous, alternating and multi pattern are also selectable.

The use of solid state switches in this unit simplifies installation and operation by eliminating the necessity of extra external diode bridges in most applications. The 3 selectable patterns can be applied independently to head lamps, front fog and rear fog or brake lamps. Any pattern, simultaneous, alternating or multi-flash can be applied to any pair of channels, e.g. front headlamps can be set to multi-flash and the rear red channels can be set to alternate mode. The unit is fully protected against short circuit and over-heating.

Fitted with internal fuse and plug and socket connections for ease of installation and commissioning.

Input Voltage:	11 -16 V DC (negative ground)
Input Current:	30 amps (maximum depending on loads) @ 14.0 V DC input
Circuit Protection:	30 Amp ATC fuse
Flasher Output
Load Current:	12 A per channel for headlamps and front fog lamps
	8 A per channel for front fog lamps
	8 A per channel for rear red lamps
Circuit Protection:	30 Amp ATC fuse
Operating modes:	14 Front user selectable patterns
	3 Rear user selectable patterns
Connections:	All connections via 12 way and 4 way plug and socket
Main Unit:	135 mm x 81 mm x 36 mm
Fixing:	90 mm x 69 mm x 4.5mm Dia
Weight:

[ View All Products ]